Metrologic TECH 10 Guide de l'utilisateur télécharger pdf (Page 8)

Figure 1

Installation of the Stand

With the Metrologic stand (Part #45479), the scanner can be positioned in a

vertical orientation. To use this stand, four 6-32 x ½" machine screws and two

#10 panhead wood screws will need to be purchased. The maximum distance

the screws should go into the scanner is ½ inch.

1. Lay the scanner face down on a clean cloth to prevent any

scratches from occurring on the output window. Position the

scanner so the red and green LEDs are pointed toward you.

2. Lay the stand on top of the scanner with the angled bracket

pointing up and toward you.

3. Align the four clearance holes to the four holes in the scanner’s

case. Fasten the stand to the scanner by inserting the four 6-32 x

½" screws into the four holes in the scanner’s case.

4. Drill two holes into the work surface that correspond with the

holes in the 254mm x 95mm (10" x 3.75") base of the stand.

5. Use the two #10 panhead wood screws to attach the stand and

scanner to the work surface. (Refer to Figure 1)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Pas de commentaire

Metrologic TECH 10 Guide de l'utilisateur Page 8