Metrologic Stratos MS2x20 Series Guide de l'utilisateur télécharger pdf (Page 36)

SCANNER OPERATION

IR ACTIVATION AREA (IR LED OUTPUT)

The StratosS’s default power save mode

†

is Dual Action Power Save Mode #2 (see page 36). This power save mode

†

turns

the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals. Any movement

detected by the IR in the activation area, shown below in grey, will cause the scanner to exit the power save mode. The motor

will restart automatically and the laser will turn back on preparing the scanner for bar code recognition, decoding and

transmission.

Figure 29. IR Activation Area Perpendicular to Package Flow (IR LED Output)

†

Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.

Specifications are subject to change without notice.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 85 86

Pas de commentaire

Metrologic Stratos MS2x20 Series Guide de l'utilisateur Page 36