Metrologic Hand-Held Scanner Guide de l'utilisateur télécharger pdf (Page 13)

SCANNER INSTALLATION: POWERED BY HOST DEVICE (CONTINUED)

3. Plug the 4 position ground jumper

into the power supply connector.

4. Turn off the host system

5. If using a communication cable,

connect the cable to the correct port

on the host device and the MCA.

If the host device is an IBM

compatible with a male 9-pin serial

port, connect the MCA to the port.

There is an optional cable

(

MLPN 51-51236) that is available for

IBM PC applications where the MCA

will not fit at the back of the

computer.

6. Plug the scanner’s coil cable into the

MCA.

7. Turn on the host system.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet the

requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

**To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power

source should meet applicable performance requirements for a limited power source.

Ground

Jumper

(direct)

Communication Cable (Optional)

MCA

Coil Cable

MS6720

Host

MCAFemale

9-pin D

Power Supply

Connector

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Pas de commentaire

Metrologic Hand-Held Scanner Guide de l'utilisateur Page 13