Metrologic Hand-Held Scanner Guide de l'utilisateur télécharger pdf (Page 11)

MS6720 INSTALLATION: POWERED BY EXTERNAL POWER SUPPLY

1. Turn off the host system.

2. If using a communication cable, connect the cable to the correct port on

the host device and the MCA (Metrologic C

onnector Adapter). If the

host device is an IBM compatible PC with a male 9-pin serial port,

connect the MCA to the port.

3. Plug the scanner’s coil cable into the MCA.

4. Check the AC input requirements of the power supply to make sure the

voltage matches the AC outlet. The outlet should be near the

equipment and be easily accessible. Plug the power supply into the

MCA and the AC outlet.

5. Turn on the host system.

Note:

a. When the scanner first receives power, the red LED will come

on, the green LED will flash once and the unit will beep

simultaneously.

b. Plugging the scanner into the serial port of the PC does not

guarantee that scanned information will appear at the PC. A

software driver and correct configuration setting are also

required for proper communication to occur.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet the

requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

Tab

Down

10 Position Modular

Connector at the end of

the Coil Cable

Female

9 Pin

MCA

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Pas de commentaire

Metrologic Hand-Held Scanner Guide de l'utilisateur Page 11