Metrologic MLPN 2159 Guide de l'utilisateur télécharger pdf (Page 9)

Back Plate Installation

With the Metrologic back plate

(Part #45473), position the scanner

in one of two directions. The two

Vertical Mount

orientation choices are vertical or

horizontal. (Refer to Figure 4). To

use this stand, use the four

6-32 x ½ inch machine screws and

Horizontal Mount

four wood screws to attach the unit

to the back plate and work surface.

The maximum distance the screws

Figure 4: Back Plate Orientation

should go into the scanner is a ½ inch.

1. Drill four holes into the work surface that correspond with the

holes indicated by an XY in Figure 5.

2. To fasten the scanner to the back plate:

z For a horizontal mount, align the four holes on the back of

the scanner with the four clearance holes located on the

back plate marked with an X in Figure 5.

z For a vertical mount, align the four holes on the back of

the scanner with the four clearance holes located on the

back plate marked with a Y in Figure 5.

3. Fasten the scanner to the back plate by inserting the four

6-32 x ½ inch screws into the four holes in the scanner's case.

Fasten the scanner and back plate to the work surface.

X Y X

X = Scanner Horizontal Mount

Y = Scanner Vertical Mount

XY = Back Plate Mounting

Figure 5: Back Plate Hole Pattern

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Metrologic MLPN 2159 Guide de l'utilisateur Page 9