Metrologic Hand-Held Scanner Guide de l'utilisateur télécharger pdf (Page 10)

Disconnecting PowerLink Cables from the Scanner

Before removing the cable from the scanner, Metrologic recommends

that the power on the host system is off and the power supply has been

disconnected from the PowerLink cable.

1. Locate the small ‘pin-hole’ on the top of the unit near the bottom of

the Voyager logo.

2. Bend an ordinary paperclip into the shape shown above.

3. Insert the paperclip (or other small metallic pin) into the small ‘pin-

hole’.

4. You will here a faint ‘click’. Pull gently on the strain-relief of the

PowerLink cable and it will slide out of the scanner.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Pas de commentaire

Metrologic Hand-Held Scanner Guide de l'utilisateur Page 10