Metrologic MS5100 Guide de dépannage télécharger pdf (Page 12)

Figure 7.

INSTALLING THE SCANNER TO THE HOST SYSTEM

USB: L

OW SPEED HID/POS USB MS5145-38

FULL SPEED USB MS5145-40

1. Turn off the host system.

2. Connect the 10-pin RJ45 male connector

of the USB cable into the jack on the

Eclipse. You will hear a ‘click’ when the

connection is made.

3. Connect the other end of the USB cable to

the host USB port.

4. Turn on the host system.

Plugging the scanner into a port on the

host system does not guarantee that

scanned information will be

communicated properly to the host

system. All Eclipse’s are shipped

already configured with a set of factory

defaults. Please refer to the MetroSelect

Configuration Guide or MetroSet2’s help files

for instructions on changing the scanner’s

configuration. It is important to check that

the scanner and host system are using the

same communication protocol.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must

meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the

power source should meet applicable performance requirements for a limited power source.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

Metrologic MS5100 Guide de dépannage Page 12