Metrologic Stratos MS2xxx Series Guide de l'utilisateur télécharger pdf (Page 24)

20

SCANNER CONFIGURATION BAR CODES

Dual Cable Scanner Configuration Bar Codes

Dual Cable Scanner Mode

The following bar codes can be used to place, as well as configure, the

scanner in Dual Cable mode.

The MS2xx0 does not need to be in scale program mode to use the

following bar codes.

Scanner = Dual Cable Mode

³999953

Places the scanner in Dual Cable mode.

In a dual cable environment, the scanner

and scale work independently. In this mode

the host must have a dedicated RS232 port

to receive the scale data and the barcode

data is sent via its own cable to a separate

communication port.

Communication Port Settings:

• 9600 Baud, 8 Data Bits, 1 Stop Bit, No Parity

There are two methods of configuring the scanner to a stand-alone protocol:

• Scan the Dual Cable Mode bar code on this page (if a scale is used)

or

• If no scale is required, scan one of the single cable protocols on

pages 22 - 29 and then scan the No Scale bar code on page 38.

Dual Cable Scanner OPOS Mode

Scanner Only

Dual Cable OPOS Defaults

³999911

Use this barcode when the scanner is to be

setup using the OPOS drivers in the dual

cable mode.

Communication Port Settings:

• 9600 Baud

• 8 Data Bits

• 1 Stop Bit

• No Parity

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Commentaires sur ces manuels

Pas de commentaire