Metrologic MLPN 2159 Guide de l'utilisateur télécharger pdf (Page 10)

Figure 3

INSTALLING THE SCANNER TO THE HOST SYSTEM

Keyboard Wedge (MS9524-47 and MS9544-47)

1. Turn off the PC.

2. Connect the 10-pin RJ45 male

connector into the jack on the

Voyager

PDF. You will hear a ‘click’

when the connection is made.

3. Connect the L-shaped plug of the

power supply into the power jack on

the PowerLink cable.

4. Make sure the AC input

requirements of the power supply

match the AC outlet. Connect the

power supply into an AC outlet.

The outlet should be near the

equipment and easily accessible.

5. Disconnect the keyboard from the PC.

6. Connect the PowerLink cable to the

keyboard and the PC’s keyboard

port. If necessary use the supplied

adapter cable (5-pin male DIN to

6-pin female DIN adapter).

7. Power up the PC.

Plugging the scanner into a port on the host system does not guarantee

that scanned information will be communicated properly to the host

system. Please refer to the MetroSelect Single-Line Configuration Guide

or MetroSet2’s help files for instructions on changing the scanner’s

factory default configuration. The scanner and host system must use the

same communication protocols.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must

meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.

To maintain compliance with standard CSA-C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC

60950-1, the power source should meet applicable performance requirements for a limited

power source.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Pas de commentaire

Metrologic MLPN 2159 Guide de l'utilisateur Page 10